About DIY engraving machine other information please visit http://www.shyidiao.com/ for more details.
As we all know, DIY engraving machine used in our daily life a very broad range. Engraving machine small power can sculpt 3D artwork, double color version, architectural patterns and small standard etc.. Engraving machine power is not only can make the small power engraving machine to do things, can also be carved large relief and relief and so on, then about DIY engraving machine it correct maintenance method is what?
1, DIY engraving machine in every continuous running time less than ten hours, need to ensure the normal work of cleaning and water pump cooling water situation. Suppose in the winter, the working environment temperature of engraving machine is relatively low, can put the water in the tank with antifreeze.
2, after each use of DIY engraving machine, be sure to clean up clean, to platform and transmission system above the dust cleared, remember driving system regularly to add lubricating oil. Note that X, Y, Z three shaft rod to use oil maintenance, the screw rod part to add some high speed, winter due to the environment of low temperature, light bar and wire rod part first with private oil cleaning, then add oil, machine transmission part or will constitute the engraving machine branch a lot of resistance.
3, when the maintenance and check of DIY engraving machine, electric appliance, must cut off the power supply equipment, wait until the indicator light monitor which did not appear and the main circuit power supply out later, go on.
4, engraving machine used to inspect the fastener after three months, Longmen on both sides of the connecting screws, screw nut and the fastening screw on both sides of the click and the screw nut are to be tightened.
After the above tells the story of DIY engraving machine, how to carry out maintenance, I believe we all have a certain understanding.