The relevant advertising engraving machine the other information please visit http://www.shyidiao.com/ for more details.
A, what caused the broken cutter advertising engraving machine
Cutter status was not much, in the operation of the time can be avoided, some skilled technical personnel on the tool advertising engraving machine properly understood, know how to avoid attack the situation. Usually, if the Polish pilot time on high strength were cut and polish, so, the tool wear will be compared serious, cutter things sometimes is inevitable; the other, methods and carving operation way is not correct, the cutting depth is too deep, or the speed is not coordinated, will form a broken knife appearance.
In two, after breaking knife should be how to deal with it
Advertising engraving machine advice in the inevitable conditions, we can carry on the replacement of new broken knife knife, then boot debugging, continue to carve. Not the same machine program may not be the same, but eventually, tool change is the same way about.
1 pause may stop the machine, to remember that the operation code;
The 2 tool change only needs to adjust the Z axis, X.Y does not move, replacement after the success, on the Z axis positioning origin;
3 find "high-grade start" input operation segment number recorded in 1, and then run the carving machine.
Remove the improper operation of the situation, when the carving machine tool wear contrast serious, need to be replaced, to avoid the attack tool broken things. Timely treatment contrast handle emergency situation a little better.