The dislocation of PCB engraving machine

You have a carving machine friends, when you have the problem of dislocation in the carving process, even if it is used in control system of the micro macro, there may be errors. The engraving machine belongs to the non-standard products, variety, the formation of dislocation reason is various. Below I detailed to explain about the problem of dislocation.

First of all, you need to check your Is it right? Carving path is wrong, wrong path will form the dislocation, so you change the way an individual or re do a way will be able to detect, if not misplaced, congratulations. If there is, it needs you to continue. Further testing is the drive, the drive sometimes overheating will cause dislocation, and even drive is broken, then you put the well shaft drive and dislocation axis driver swap, see Is it right? Also dislocation, so you will detect is why not drive. The drive is not there a central will have the dislocation, is electromagnetic interference, so that more trouble, because some manufacturers such as Mister engraving machine is used in shielding line, thus preventing the reasons, some is the use of ordinary wire, you miserable, voltage instability will often produce electromagnetic interference the formation of dislocation. One of the most important reason is the motor of the problem, but the problem is often some people neglect. The so-called dislocation is the motor drives the tool motion and location of the software is not consistent, if the motor power lack, how to produce sufficient driving force, which is why big partial dislocation is generated by running at high speed. A small motor will displace absolutely at high speed, but the speed to reduce some of these dislocation problem will disappear. Only change the motor such condition. We Mingshi engraving machine is rarely presents the problem of dislocation, why? First we use is good motor, the motor on the market for two is a copper wire, electric current is big, torque is big enough, the match your way, the motor is used in our Mingshi Machinery Equipment Co. ltd.. Some are aluminum envelope, this current is relatively small, of course, the torque is small. This is why some manufacturers price relatively low, absolute have maoni. When consumers buy equipment will not only result in material waste will also spend a lot of time, we Mingshi engraving machine without such problems, the invisible for customers to save a lot of cost.