Shanghai engraving machine, engraving machine | give you to the point of lubricating oil!

If your stone engraving machine processing time, and the large amount of work. To every half a month for a machine maintenance smooth. It can extend the useful life of carving machine. The Conway to specific and we tell about a smooth way, for our reference.

Smooth way: Y axis: the side guide rails can be directly oiling, bottom bracket screw can also be obtained from the Department of oil. The X axis: before and after the unloading plate screws, left to relax again, raise a head shield, right carry, mixing the oil into thrust bearing screw, guide rail, bearing and the right wire head.

Axis thrust bearing cover: open, screw, guide rail, bearing at the bottom will stick out a mile, this work is the machine is in operation to mixed oil slick. Other protection: hand pump, cutting spindle, which is to often change circulating water to each other, adhere to the circulating water clean, suitable water temperature, to prevent the pump outlet obstruction, or damaged water-cooled cutting spindle operating at high temperatures caused by component.

To portray refer to the following: sharp point of view: image shadow disposal process, relevant parameters. General line acquisition has a certain angle, when I set a viewpoint of value, such as tacit approval of 60 when more than 60 degree angle, system will be smooth to dispose of their, make it into a smooth curve; when less than 60 degrees, the system make it a disposition to a corner, not change its shape. Given this viewpoint of value only as a boundary!

The shadowed generalized more accurately, stalking error: the smaller the value. Shanghai engraving machine, engraving machine corresponding calculation time is long; the larger the value of, is shadowed generalized error is large, but the corresponding calculation time shorter. Fairing times: refers to the number of curves and disposal, when the given value is bigger, the effect will be better disposal!