Carving machine | how quick install engraving machine tool correctly?

How fast device engraving machine tool correctly? Be known to all, as long as the cutter device of engraving machine correctly, carving picture precision machine carved out will be highest,and the cutting tool in use is not easy broken, how to quickly correct device engraving machinetool? Carving machine list such steps, hope can help you.

There are a lot of gap 1 collet, every time before clamping tool, needs to use gasoline or WD40cleaning agent will chuck scrub clean, and check, the eradication of chuck crevice residue;

Cooperation on axis 2 chuck and shaft taper touch touch, if not good, is not simple positive toolinstalled, to ensure that the cone has a good touch. Should use gasoline or WD40 cleaning agent will be scrubbed clean before on the knife shaft cone;

3 the chuck into the pressure cap, gently rotating the clamping spring clamp groove ratio, rangeconcave pressure cap eccentric, along the direction of the arrow uniform force chuck, can putthe pressure cap;

4 chuck and a pressure cap to device in the machine tool spindle, tool cylindrical shank wiped clean after loading blessing hole, acknowledge chuck and tool is placed, the pressure capscrewed into position by hand. Then use the wrench uniformly tighten cap, until the tool to beused;

When 5 pine knife wrench counter to the direction of the screw cap, if needs to replace chucktime, release the pressure cap out of the chuck and tool, remove the tool, along the direction of the arrow to force chuck, the launch, and then based on the chuck other aperture required fromit.