Methods the carving machine | power outage continued carving carving machine

More about carving machine information please pay attention to http://www.shyidiao.com/.

With the development of society, carving machine is used in advertisement, woodworking industries. In a time division processing making use of carving machine, fear most is the electricity suddenly, cause the processing can not continue, electricity came to start all over again. How can finish carving machine to a breakpoint carving machine continued processing?

In the face of cutter materials used, each will leave a dot mark at the beginning point, so I would not worry about the outage problem. Such calls, then knife on dot mark previously left, re is the carving knife, but the table, encounter this problem how to deal with power outage continued carving of the problem?

Senior start to look at the current line number, when power failure, in the beginning of a little forward advanced fill line number one point on the line, certainly, the machine will in this line began carving. But, if you carve very fine thing, just start carving, and Z only a few wires down, if continued carving words will see continued carving seams. You try will know.

If it is a normal shutdown, carving machine system will record the current location and the number of the machine, but suddenly power off, system time to keeping the current position, the serial number is about before. The breakpoint continue on the line, but have to find the origin of the current number. If the heart of doubt, method of nuclear carving machine is the most benzene the original file deletion has been carved local re output is, also do not charge more events, but must not delete the bottom left corner, because it is the origin.

Remember that some use of carving machine engraving machine processing consumer tips, so that we can make progress a little consumption efficiency, for the processing of regular consumption decreased a little trouble.