Method for solving problems | engraving machine carving machine

Once the stone engraving machine carving knife attack offset, don't say rose high precision operation how, is shallow carving will tend to very, very severe. So the hand contact 1-2 seconds can in our practice in the process of manufacturing, do not cross 60 degrees; only by hand touch, about 70-80 degrees; a few drops of water dripping Huoluo gasification, is more than 90 degrees, is to cut the copper loss and iron loss. Carving machine this condition we can choose antifreeze instead of water, if the conditions you can buy engraving machine spindle in optimal selection when air rather than water.

Of course, track on the stone engraving machine engraving machine (side rails or compass) and rack always clearing and oil protection, on the wire to check whether the aging or broken, prevent leakage of. Carving machine in the processing of some heavy stone heavy stone carving machine is different from usually light stone engraving machine, not only because of its bearing capacity than light machinery, more table method it used rack drive carving high power, power in what circumstances we stone carving machine is relatively low, current are usually larger, and the high harmonics, alternating current frequency also increases with the speed change, thus the stepper motor widely exist have a fever, and severe condition than usually AC motor.