Desktop engraving machine | usual to how to maintain the engraving machine

The original should be divided into two processes, one is the maintenance, followed by maintenance, go into details: some details about carving machine maintenance should pay attention to the:

Engraving machine on every work long time, standard is 10 hours a day, if beyond words, need frequent replacement of cooling water, the purpose of doing so is to ensure that the cooling water clean, avoid because of the cooling water is not clean a pipe blocking, assuming that the cooling water is less, but also often add frame, avoid appear appearance, this will constitute the water temperature is too high, burn carving machine pump, but in the winter time, because the temperature is too low, it may appear appearance effect of cooling water ice work, then you can put the cooling water with antifreeze. Engraving machine after each use, remember to clean, do not let the machine covered with dust and dirt, especially the transmission system, in order to maintain transmission system and use, to regularly add lubricating oil.

Desktop engraving machine on the maintenance of the engraving machine should pay attention to the first: don't let your machine in the power-off state for a long time, it mainly about some business like in cold season and let the machine use condition, simple form moisture too serious, motor brush corrosion, the results is the main shaft of the motor is damaged, the whole machine cannot work condition there are many engraving machine spindle; bearing with a direct current is a current, in order to make the DC motor to work longer, we recommend the use of brush to brush the moisture, which can effectively avoid the use of chemical corrosion, let the motor life more durable.